How to Grow Potatoes in Aquaponics

Set up a plastic fish pond according to the manufacturer's directions. Add water to the fill line and allow it to sit 24 to 48 hours so the chlorine in the water completely evaporates.

Drill a 1-inch-diameter hole for plastic tubing in the side of a 5-gallon bucket, 4 inches from the top. Also drill a hole through the lid of the bucket at the same diameter as the pump tubing.

Place the bucket on an upside-down garbage can next to the fish pond. Attach a 3-foot length of 1-inch plastic tubing to the hole in the side, using silicone sealant to seal around the hole. Allow the silicone to dry completely. Fill the bucket with clean gravel.

Place the lid on the bucket and push the pump tubing through the hole. Seal with silicone sealant and allow to dry. This bucket becomes the bioreactor, removing the ammonia from the fish waste through bacterial action.

Nest two plastic garbage cans together. Measure the distance between the tops of the two cans and add 1 inch to the measurement. Separate the garbage cans.

Mark the measurement on the side of one garbage can. Drill a 1-inch hole through the side of the can. This can becomes the reservoir for the hydroponic system.

Turn the second garbage can upside down. Drill 10 to 15 1/2-inch diameter holes in the bottom of the can. Line the bottom with fiberglass window screening. This becomes the planter.

Place the reservoir on cement blocks next to the fish tank and bioreactor, with the hole in the side facing the fish pond. Attach a 3-foot length of tubing to the side of the can, sealing it with silicone sealant. Allow it to dry completely. Place the other end of the tubing in the fish pond.

Set the planter inside the reservoir. Place the end of the bioreactor hose in the top of the planter. Raise the base of the bioreactor with cement blocks if necessary so the water will drain freely into the planter.

Plug in a pond pump and start pumping water into the bioreactor. Allow it to fill the bioreactor and drain into the planter until water comes out of the tubing in the reservoir, returning to the fish pond.

Add fish to the pond. Generally, shrimp, crayfish or tilapia are grown in food-producing aquaculture systems. Allow the system to run for one to two weeks before planting the potatoes.

Rinse perlite thoroughly and mix equal parts perlite, coconut coir and vermiculite. Fill the planter one-quarter full with the planting mix. Place six seed potatoes in the planter and cover with 2 inches of planting mix.

Add more planting mix as the potato vines grow, covering all but the last two sets of leaves. When the vines reach the top of the planter, allow them to grow freely. Harvest the potatoes when the vines die back in the fall.