Skim dirt and debris from the surface of the LOOP-LOC cover and suction off any water using a pool pump.
Position the installation rod so that it's facing the LOOP-LOC cover.
Slide the rod carefully over the anchor bolt and press it down while rotating. Continue rotating until the rod's heel is directly in between the retaining ring and the anchor bolt of the cover. This usually takes about a 180-degree turn.
Slide the training ring toward the LOOP-LOC cover. Stop sliding when the ring comes off the bolt. When this happens, the pool cover can be removed. Slide the cover off carefully so that no dirt on the top surface gets into the pool water.