Pinnacle Hurricane Jacuzzi Instructions

Press the "Mode" button on the control panel to turn on the hot tub once it is installed. The first time you power on the hot tub, it will go into "Primer" mode for the first 5 minutes and you will see this on the display screen. When the screen changes to "Standard" you are ready to continue.

Press the "Warm" button and the current temperature of the water in the hot tub will begin flashing on the screen. Press the "Warm" button again and the temperature will stop flashing. Press the "Warm" button again to increase the temperature, or the "Cool" button to decrease it. Each press will decrease the temperature more. When you reach the desired temperature, do not press the button and after 3 seconds you will see the current temperature again and the hot tub will start.

Press either the "Jet 1" or "Jet 2" button to turn on the underwater jets in the hot tub once it reaches the desired temperature. This will activate the blowers until you press these buttons again to turn them off. Press the "Aux" button to activate the waterfalls in the hot tub and press it again to turn them off.

Press the "Light" button once to turn on the lighting system in the spa. Press the button again to cycle to a different color. Each press will change the color of the lights. Once all the colors have been cycled through, press the "Light" button again to turn them off. The lights will go off on their own after 4 hours.

Press the "Mode" button when finished until the display reads "Sleep." This will put the hot tub into sleep mode in which none of the internal parts will be working. In this mode, it is safe to leave the hot tub and place the cover on it until you are ready to use it again.