Dolphin HD Pool Cleaner Instructions

Cleaning the Pool

• 1

  Move the caddy so it is in the shade and about 10 feet from the pool edge and ensure that the cable on the unit can reach all the walls of the pool.

• 2

  Remove the Dolphin from the caddy.

• 3

  Lock the handle into a diagonal position on the Dolphin. Reposition the handle after each use by pressing the yellow latch down and sliding the arm to the opposite end of the slot.

• 4

  Connect the cable from the Dolphin to the power supply on the back of the caddy. Start by lining up the notch and groove, and then push the cable end into the plug and firmly tighten the collar.

• 5

  Place the Dolphin into the pool and rock it from side to side so it releases trapped air.

• 6

  Release the Dolphin and it will sink to the bottom of the pool.

• 7

  Plug the power cord, from the power supply on the caddy, into a grounded outlet.

• 8

  Turn on the power. The Dolphin will automatically complete an 8-hour cycle. If you want it to perform another cycle, shut off the power for 30 seconds than restart it.

Removing the Dolphin from the Pool

• 9

  Turn off the power and unplug the unit.

• 10

  Pull the cable gently to bring the Dolphin to the surface.

• 11

  Use the handle to pull the pool cleaner from the water, never the cord.

• 12

  Tilt the Dolphin on its side on the edge of the pool and let it drain.

• 13

  Turn the unit upside down and remove the two yellow locking clips than remove the bottom lid assembly.

• 14

  Remove the two black filter bag clips on each side of the filter and take the filter out of the Dolphin.

• 15

  Turn the filter inside out and spray with a garden hose until the filter is clean. Wash the filter in a washing machine, on the Synthetics cycle, every two months.

• 16

  Pull the yellow inlet cover upwards and remove it from the Dolphin.

• 17

  Remove the inlet flaps and clean the cover, the inlet flaps and under the locking clips. Reinstall the inlet cover and the flaps.

• 18

  Turn the filter right side in, so the tag is on the outside, and set the filter so each pocket slides over the metal frame. The elastic top fits over the two metal frames and the white lip on the bottom lid.

• 19

  Adjust the top of the filter so all excess material is in the center of the two frames.

• 20

  Slip the black filter clips in place on the top of the filter and frame.

• 21

  Replace the bottom lid assembly and lock it into place.

• 22

  Remove any debris caught on the tracks, you can turn the roller brushes to move the track if needed.

• 23

  Set the Dolphin upright and turn the yellow impeller tube counterclockwise to remove it. Remove any debris from inside the impeller and replace the tube.

• 24

  Set the Dolphin upright on the caddy, wrap the cable loosely around the hooks and store the unit in the shade.