Instructions for the Madaga Home Gazebo

Slide the open pipes of each left frame into the open pipes on each right frame. The frame pieces sit at the top of the gazebo. There are eight total pieces, with four left frames and four right frames.

Push the screws into each predrilled hole on the frame pieces. Tighten the screws to secure the frames together.

Set the column pieces straight up on the ground.

Hold one frame piece at the top of one of the columns. Insert the screws into the predrilled holes on the frame and tighten it into the column. Repeat with the other column and frame pieces until all frames are connected to the columns, resulting in a square configuration.

Insert the pegs into the holes on the bottom of each column. Tap the pegs into the ground. The pegs secure the gazebo to the ground.

Position a ladder next to the gazebo. Climb up to the top so you can access the top of the gazebo.

Insert each medium bar for the roof into the short bar for the roof. Screw the hook into the bottom of the center fixture. Alternate pushing the end of the medium bar into one of pipe fixtures on the center fixture. One the alternating open ends, insert the long bars.

Insert the open end of long bars into the arches on the frame. Push the medium and short connected sections into the corners of the frame. Insert the screws into the predrilled holes where each pole meets the frame and tighten.

Open and position the small canopy on the top of the roof.

Insert the end of the top roof connectors into the top center fitting.

Insert the screws into the predrilled holes on the top roof connectors, and tighten them through the bars at the top of the roof.

Tie the small canopy around the bars at the top of the roof.

Open and lay out the large canopy over the roof of the gazebo. Tie the ends of the gazebo to the frame bars.

Open the mosquito net. Position the top along the top of the frame from the inside. Secure the net to the frame with the plastic rings.