How to Apply DRYLOK Concrete Protector

Surface Preparation

• 1

  Remove mildew, dirt, wax and debris from the surface with a wire brush or scraper. Use DRYLOK Concrete Cleaner and Degreaser to remove stubborn grease stains.

• 2

  Remove all white, powdery deposits that are visible on the surface with DRYLOK Liquid Etch.

• 3

  Rinse the surface with clean water, and do not let the DRYLOK Liquid Etch dry on the surface because this will hinder the penetration of the concrete protector.

Concrete Protector Application

• 4

  Stir the concrete protector thoroughly. The mixture has a milk-like consistency, but will dry clear.

• 5

  Coat a brush or roller with DRYLOK Concrete Protector and spread it evenly. Apply one coat of the protector to the surface, and wait six hours for the protector to dry.

• 6

  Test the protection by sprinkling droplets of water onto the surface. If the water seeps into the surface, you will need to apply a second coat.