Directions for Zenith Motion Flood Lights

Remove the battery cover lid from the back of the motion sensor module. Slide the switch to the right so that it is beneath the "Night Only" text. Insert two batteries into the battery compartment, lining up the positive and negative poles of the batteries with the same name-labeled text inside the compartment. Replace the battery cover lid.

Place the mounting plate over the rod on the back of the motion sensor module. Screw the sides of the mounting plate into the back of the module with a Phillips jeweler's screwdriver.

Insert the tip of a flat-edged jeweler's screwdriver into the seam between the bottom lid and the module. Lift up on the tip to loosen the bottom lid. Pull the bottom lid off.

Rotate the knurled knob inside the bottom halfway clockwise. Replace the bottom lid.

Place a ladder next to the side of the house where a flood light socket is located. Screw the base of the flood light module into the flood light's socket. Screw the base of a flood light into the socket on the flood light module.

Place the mounting plate on the back of the motion sensor module against the wall next to the flood light socket.

Screw wood screws through the plate into the wall with a Phillips screwdriver. Loosen the screw on the rod on the back of the motion sensor module with the Phillips jeweler's screwdriver.

Angle the motion sensor module down so that the front is facing toward the ground. Tighten the screw.