Create a simple sketch of your yard with paper and pencil, and circle the high and low areas with different colors. Draw a course for a walkway, and mark a sunny location for a plant bed and any other features you’d like to add. If you have specific shrubs or flowers in mind, choose the spot based on the needed growing conditions. For instance, high areas tend to be dry, while low areas are good for flood-tolerant plants.
Lay ropes on the ground to mark the sides of the walkway. Measure the width using a tape measure, and adjust the ropes so the width is 36 inches for a secondary trail or 4 feet for a main walkway.
Place stepping stones or large pieces of slate between the ropes, spaced about eight inches apart. Set the stones to the side of one rope, maintaining the spacing. Dig out the grass and topsoil beneath the location for each stone with a shovel. Remove enough soil to fit a 1-inch deep base plus the thickness of the stones.
Spread a 1-inch thick bed of course sand in the hole for each stone. Drag the side of a board over the surface of the sand to make it smooth.
Drop the stepping stones into their holes directly on top of the sand. Use some of the soil you removed earlier to fill in any gaps between the stones and the ground, and pack the dirt down so the stones are stable.
Mark the borders for a raised plant bed with ropes or a hose. To access the plants from all sides, consider making it a 4-foot square. Use a flat shovel to remove the top layer of grass and roots from the location, and dig down the high area until it is level with the lowest side of the garden area.
Set landscape timbers on each side until you have enough to stack to the desired height of your garden. Drill pilot holes through each stack of timbers on a slight angle. Stack the first side of timbers, and use a sledgehammer to drive rebar through the holes into the ground to stabilize them. Repeat this for each side, aligning the ends to make a 45-degree angle. Drill brackets and screws to the inside corners of the timbers to attach the adjacent sides.
Line the bottom and inside walls with weed barrier fabric.
Fill in the hollow square with the soil you removed for the walkway. Use native topsoil to fill the remaining expanse. Dig a hole for each plant as deep as the root ball plus one inch. Place the plants in the holes, and cover them with soil. Spread two inches of mulch over the surface to prevent erosion.