Can You Install a Chain-Link Fence Onto T-Posts?

T-Posts

• T-posts are a form of fencepost typically used for cattle fencing. The posts are set into the ground using concrete and are further supported by wooden posts positioned every eight to 10 feet. There is no top bar when using T-posts, but the posts do have small ridges that allow the fencing to sit without sliding. Choose heavy-duty T-posts that are rated to handle the weight of the selected fencing.

Chain Link

• Chain-link fencing is a form of thick, woven fencing. The woven links form a diamond shape, and the fence can be cut and a section of wire removed at any point to shorten the fence. Chain-link fence is secured with thick wire hooks, similar to those used for ranch fencing. Be sure the weight of the fencing is appropriate for the selected posts, otherwise the fence could fall down.

Preparation

• When preparing the site for fence installation, the first step is to determine how level the ground is. Any rises in the ground must be either lowered or the fence must be installed higher. For a gradual incline, the fence simply follows the incline. If your property has a high amount of small hills and ridges, consider renting a leveler to move the dirt to the desired level.

Installation

• Mark the post locations with chalk paint, spacing them no farther than three feet apart. Dig the holes so that the bottom 2 feet of each post will be buried. Pour 6 inches of concrete into the hole and set the post, making sure it is level. Fill the rest of the hole with concrete and check again for level. Let the posts cure 24 hours before installing the fence. Once the concrete is dry, roll out the fencing and attach it to the first post. Stretch the fencing as hard as you can between posts to avoid slack. Secure the fence to the posts using the wire hooks.