# How to Set The Code on a Stanley Garage Door
Setting the code on your Stanley garage door is an extremely important step in protecting you and your family from possible intruders. The code ensures that only those with intended access can get in and out of the house without a key. To some, the prospect of setting and memorizing a code may seem like a difficult task. However, with proper instruction, it is actually quite easy.
Things You'll Need
- Garage door
- Garage door opener keypad
Instructions
-
-
1
Press the key that reads "Access Learn" twice. The red indicator light will blink twice each time the button is pressed and will remain illuminated after the key has been pressed the second time.
-
2
Enter the Stanley factory set code of 1-2-3-4. If you are trying to reprogram the garage door after a previous code was installed, simply enter the existing code.
-
3
Enter the new access code that you have selected. Select a code that you can easily remember but will not be obvious to someone trying to break into your home.
-
4
Press the "Access Learn" button one more time. Pressing this button deletes the old code and sets your new access code. Allow the lights to stop flashing, and then enter your new code to see if it is working properly.
-
1
Home Alarm Systems
- How to Change the Bottom Weatherstripping on a Garage Door
- How to Replace the Cylinder Lock on a Garage Door
- How to Fix the Middle Hinge on a Garage Door
- How to Set the Coil Springs Tension on an Overhead Garage Door
- How to Set the Travel on a Craftsman Garage Door
- How to Reengage the Carriages on Garage Door Genies
- How to Reset the Code on a Craftsman Garage Door
- Setting the Code on the Craftsman Garage Door Opener
- How to Change the Security Code on a Craftsman Wireless Door Opener
- How to Change the Access Code on the Keyless Entry Keypad for Garage Door Openers
- How Do I Set the Code on My Home Security System?
- How Do I Change the Code on My Wireless Garage Door Keypad?
