How to Program an Ademco Key Fob

Ademco is a home alarm system manufactured by Honeywell that is set up in your house to offer security to your entry doors. These alarm systems can be synced with remotes and key fobs that are used to turn the alarm on and off. You can program the remotes in just a few minutes from your system with only a couple of clicks of the buttons on the remote and the alarm keypad.

Instructions

- 1
  Stand by your alarm keypad with your remote.
- 2
  Press and hold the A, B and C buttons on your remote. Hold the buttons until the LED light on the remote turns on.
- 3
  Enter your alarm code using the buttons on your remote. If your code is 326, press the A button three times, the B button two times and the C button six times to enter the code.
- 4
  Wait for the LED light to blink, and then press and hold the D button on the remote.
- 5
  Hold the D button until the LED light flashes and then turns off.

How to Set First Alert Timers

How to Replace an ADT Motion Sensor Battery

Home Alarm Systems