Directions for an AAS-100 Alarm

Alarm Setup

• 1

  Insert the controller's power cord into the unit and plug the other end into a standard electrical outlet. Turn the controller over and push the power switch to the "On" position. Charge the system for eight to 10 hours.

• 2

  Place the indoor alarm siren next to the controller. Plug the siren's cord into the port on the left side of the controller.

• 3

  Plug your telephone service line into the jack labeled "Line," and your telephone line into the jack labeled "Phone." The jacks are directly beneath the siren port on the side of the controller.

• 4

  Plug the power cord of your outdoor siren into an electrical outlet. Press and hold the "Panic" button on the controller keypad until you hear a long beep, then flip the "Power" switch to the "Off" position.

Alarm Programming

• 5

  Turn the controller on and enter the default password "1 2 3 4" on the keypad. Press the "Pro" button in the lower left-hand corner to enter programming mode.

• 6

  Activate each motion detector individually by turning it on and pressing "7 1 * (01-05) 3 #" on the keypad, assigning each one a number from 01 to 05. Wave an object in front of it until you hear a double beep, then press "Exit" on the keypad and turn the detector off.

• 7

  Activate the door and window sensors by pressing "7 1 * (09-32) 1 #" and assigning a number from 09 to 32 for each sensor. Trigger each one by placing the sensor next to the matching magnetic bar and then pulling it away. Listen for a double beep, then press "Exit."

• 8

  Change the default password by keying in "1 0 * (4-digit password) #" and waiting for a double beep. Press the "Exit" key to set your new password.

• 9

  Set your alarm system and exit time by keying in your new password and pressing "Pro." Enter in the number sequence "2 8 * (00-30) #" and replace (00-30) with the delay time in minutes.