How to Wire a DS100

The DS 100, or Door Sentry 100, is an alarm system designed to monitor doors and windows, and provide an audible and visible signal in the event of a problem. The system can be flush, desk or surface mounted and can monitor any device that utilizes open or closed contact switches including heat detectors and magnetic door switches. While the wiring process can be complicated, a generous amount of support documentation is available directly from the manufacturer.

Wire stripper

Instructions

- 1
  Connect the power source to the screw connectors labeled "T1" and "T2" on the control unit provided with the DS100. The control unit has multiple screw connectors on it and is labeled "PK2019".
- 2
  Connect the "Tone Off" button to the connectors labeled "N" and "B" on the control unit. The button's negative wire should be connected to the "N" or negative screw connector.
- 3
  Connect the unit's speaker to the inputs labeled "P" and "S" on the control unit. The speaker's positive wire should be connected to the "P" screw connector while the negative wire should be connected to the "S" or speaker connector.
- 4
  Wire the "Tone Off" lamp in between the "P" connector on the control unit and the wire from the "Tone Off" button and the "B" connector.
- 5
  Wire the "Test" button by connecting the negative wire to the "N" connector on the control unit and connecting the remaining wire to the "X" connector on the actual warning panel.
- 6
  Follow the directions provided by the actual switch manufacturer before connecting the switches to the labeled inputs on the warning panel.

How to Program a DSC Power 832 Security System

Why Is My Burglar Alarm Beeping?

Home Alarm Systems