# How to Change Garage Doors on My Genie Remote
Genie garage opener systems include a remote control for use in your vehicle. Pressing the programmed button on the remote sends a digital message to the opener, causing the unit to raise or lower the garage door. It may be necessary to assign your remote to control a different garage if you have had the main motor head replaced. While most programming is done during installation, it is possible to add or remove a remote at any time.
Things You'll Need
- Stepladder
Instructions
-
-
1
Stand on a stepladder beneath the new unit and hold the "Program/Set" button for approximately five seconds until both LEDs next to the button glow blue.
-
2
Release the "Program/Set" button. The long LED light should go out, leaving the circular one glowing blue.
-
3
Press and release the "Program/Set" button again; the long LED should glow purple while the circular one goes out.
-
4
Press the button twice on the remote control that you want to control the door. The first time the LEDs will flash purple, and the second time they should flash blue and go out.
-
5
Test the remote. The door should open and close whenever you press the button you chose during the previous step.
-
1
Previous:
General Home Safety
- How to Change Traditional Closet Doors
- How to Set Up Two Garage Doors with the Smart Learn Button
- How to Insulate Garage Doors
- How to Change a Genie Garage Door Dip Switch
- How to Replace a Genie Garage Door Remote
- How to Change a LiftMaster Garage Remote Code
- How to Change Bifold Doors
- How to Change Mirrored Closet Doors
- How do I Convert a Three Button Door Opener to a Remote?
- How to Program a Garage Remote Control
- How to Change a Garage to a Den
- How to Build Garage Doors
