Slide the faceplate over the electric strike and secure it with the screws provided and your Phillips screwdriver.
Locate the wires in the frame that have been coursed there from the card reader or other activation device. Connect the wires on the back of the electric strike to the power wires in the frame using the male and female connectors provided.
Stuff the connected wires into the frame behind the cutout and place the strike into the cutout.
Close the door to see where the door lock latch lands. Use a pencil to mark where the center of the latch lands.
Pull the strike out of the frame. Then loosen the two screws on the side of the strike body that holds in place the two ramps that protrude out of the face of the strike. Slide the ramp assembly until the gap in between the two ramps is centered on the mark you made on the faceplate, and then tighten the ramp set screws.
Place the strike in the cutout and secure it with the provided screws.
Use a key card and activate the strike. Pull the door to test if the strike works and gives way allowing the door to open.
Watch this video for installation: www.youtube.com/watch?v=X7U6rrTPe-U