Measure the width of the wall where you need to install the foam board with the tape measure and make a note of the measurement. Measure the width of the foam board and make a note of the measurement.
Divide the width of the wall by the width of the foam board. This gives you the number of foam board pieces needed to cover the wall and masonry ties.
Apply construction adhesive to the surface of the foam board with the caulk gun.
Position a sheet of the foam board insulation over a masonry tie. Press on the foam board to adhere the construction adhesive. Repeat this step to cover all of the masonry ties with the foam board.
Apply a bead of caulk along the seams where two pieces of the foam board meet to create a seal. Allow the construction adhesive to dry for 24 hours.
Drill a hole at the top of the wall between the masonry ties using the power drill with an attachment for a hole saw.
Place the nozzle of the blower hose over the hole you drilled in the wall. Turn on the blower and begin filling the cavity between the masonry ties with insulation.
Remove the nozzle from the wall when the cavity is full. Fill the hole with spray foam and then scrape away the excess with a putty knife.