How to Use a Strait-Line X3 Laser Level

Laser

• 1

  Clean the surface of the wall to which you will affix the X3 Laser Level. Remove the red adhesive tape liner from the strip. Line up the adhesive tape with the marked area on the X3 and affix to the unit. Remove the black side of the adhesive tape. Press the X3 against the clean wall, and hold for 30 seconds until the X3 is sturdily affixed to the wall.

• 2

  Turn on the X3. Choose either a horizontal or a vertical laser orientation by rotating the X3 along its axis. Use the on-board bubble level to ensure the laser beam is completely level. Further adjust the laser orientation by using the micro-adjust knobs on the top of the X3.

• 3

  Mark all appropriate locations along the straight laser beam with the pencil before proceeding. Mark spaces on adjacent walls with your pencil after you release the adjustment knob and angle the laser level at the adjacent wall via the bubble level. Adjust the length of the beam for smaller work areas by pressing down on the laser side of the laser arm. Adjust the beam for longer work areas by pressing down on the bubble side of the laser arm.

• 4

  Grasp the X3 in your hand firmly and slowly pull away from the surface of the wall when finished using the laser level. Remove the adhesive tape from the X3 before storage and clean any residue.