Pull or push in the foot of the recliner. Then push it over on its front edge,. The back of the chair should be facing upward.
Locate the screw in the bottom of the handle. Remove the screw from the handle using an electric drill fitted with a hexagonal, T-30 Torx bit. Pull off the handle and the escutcheon plate from the pin on the side of the recliner.
Place the new escutcheon plate from the handle kit and handle over the pin. Then replace the screw and tighten it in place with the screwdriver.
Turn the recliner back over and test the handle to make sure it is operating efficiently. If not operating correctly, retighten the screw in the handle.