# How to Replace the Belt on the Washer Front Cover of a GE Washer Dryer Stacking Unit
The belt on the motor of the GE washer on a GE Washer/Dryer stacking unit is critical to the performance of the machine. A broken belt will cause the motor to fail at properly operating the appliance, requiring immediate repair. You can fix your GE washer's belt at the front of the assembly by accessing the part via the rear access panel on the machine. Previous washer troubleshooting experience is not necessary.
Things You'll Need
- Phillips screwdriver
- Crescent wrench
Instructions
-
-
1
Ensure the washer is empty. Disconnect the power cord from the power outlet.
-
2
Use a Phillips screwdriver and a socket wrench to remove the various screws and bolts securing the back of the cover to the washer.
-
3
Locate the belt at the front of the open washer assembly. Loosen the belt by using a crescent wrench. Twist the bolt on the motor bracket counterclockwise with the wrench to free the belt.
-
4
Slide the belt off and slide the new, replacement belt on in its place.
-
5
Tighten the motor's bolt back up with your crescent wrench. Tighten the bolt until there is about 1/2-inch of give in the belt's center.
-
6
Secure the back of the GE washer by reinserting its screws and bolts.
-
7
Reconnect the power cable to the power outlet.
-
1
General Home Repair
- How to Replace the Belt on a GE Profile Performance Dryer
- How to Replace the Front Door Seal on a Samsung Washer
- How to Access the Belt on My Frigidaire Washer
- How to Remove the Front Cover of a Frigidaire Washer
- How to Replace the Belt of a GE Front-Load Dryer
- How to Check the Belt on a Samsung Front Loading Dryer
- How to Replace the Blower Belt on a Whirlpool Cabrio
- How to Replace the Front Door Boot Seal
- How to Replace the Belt in the GE Top Loader Washer
- How to Replace the Front Boot on a GE Washer
- How to Replace or Repair the Belt on a GE Profile Dryer
- How to Stack the GE Washer WSXH208HWW
