How to Fix an Epoxy Glazed Finish

Epoxy is often used to repair wood that is cracked, broken or rotted. By simply applying the product to the unhealthy wood, you make it stronger, protected and more aesthetically pleasing. Epoxy is not only easy to apply, but it will likely last longer than the wood underneath. Epoxy is fairly strong and holds up well against the elements; however, dents, scratches or nicks in the epoxy are always a possibility. Fortunately, you can fix the problem in little time.

Cleaner
Sandpaper
Putty knife
Epoxy
Glaze
Brush or sponge

Instructions

- 1
  Clean the affected area with an all-purpose cleaner to remove any dirt, dust, grease or other materials that could prevent the epoxy from setting. Sand down the area around the imperfection with 80- to 120-grit sandpaper to get the area as smooth as possible. Doing so will likely take some time, since there is glaze on top of the epoxy.
- 2
  Follow the mixing directions on your epoxy containers, as each brand often has its own specific technique. A common technique is to mix equal parts of both the epoxy and the consolidant with a stiff putty knife for two or three minutes, until they are completely incorporated.
- 3
  Work the epoxy into any crevices or over the problem areas with your putty knife. Then smooth any remaining epoxy with the knife so that it is flush with the surrounding wood. Check the epoxy's hardness after about 24 hours. Press your fingernail into the epoxy and if it doesn't leave any impression, the epoxy is set.
- 4
  Smooth the epoxy with sandpaper. Use an 80- to 120-grit for best results.
- 5
  Apply the glaze to the epoxy according to the glaze's directions. Most glazes are simply applied with a brush or sponge; however, read the directions, as they can vary per brand. Allow the glaze to completely dry before touching.

How to Use a Butt Splice

How to Fix Holes in a Paper Screen

General Home Repair