How to Construct a Box Culvert Bridge

Excavate for your bridge assembly with a backhoe; finish-up work can be done with shovels. If the bottom of the excavation is soft and muddy, you may need to excavate 6 inches deeper than required and add crushed rock or gravel to get a good base. It all depends on what type of traffic you are anticipating. For normal residential, rural or suburban drives, extra heavy duty construction is not required.

Put on safety glasses and protective leather gloves.

Construct one of the side panel assemblies by first deciding how many 5-by-5 timbers you will need on each stack. Measure from the top of the drive surface to the bottom of where the drainage will be. Cut six pressure treated 2-by-4s the same length as the stack height and make two panel assemblies. Keep the ends of the timbers -- which all should be the same length -- square.

Standing the side assemblies on edge, add the six top 5-by-5 timber cross members, which have been cut to 3 feet, 2 inches long. Predrill holes and nail these in place with timber spikes. Add the 2-by-6s, ripped to 5 inches wide, for blocking between the top 5-by-5 cross members. Turn the assembly upside down and add the six bottom 2-by-4s.

Have the top of the bridge assembly facing up again, and add the top deck using 9 or 10 2-by-4w that are 12 feet long. Set the heads of all nails on this deck below the surface using a pin punch or piece of bar steel. This completes the assembly of the box culvert bridge.

Haul the bridge assembly to the site and off load it into the previously made excavation. If you have access to a tractor with a front end loader, use it and chains to lift and set your bridge. Otherwise, slid the bridge off the trailer on timbers or poles. The entire assembly will weigh 400 to 600 pounds, so be careful and be safe.

Begin backfilling earth into the voids at each face after you're sure the bridge is where you really want it. Remember that the top surface of the deck should be 3 to 4 inches above the drive surface. This allows for settlement and the "squashing in" factor. Compact the material as you go, about every 6 inches of depth. Use gravel/rock/clay as a very stiff fill for the last foot of depth.