How to Install the Install Bay IB200

The IB200 is a battery isolator/relay that is attached to larger batteries, such as car batteries, that are connected to secondary batteries. For example, if you have a truck, SUV or RV that has two batteries the IB200 prevents surge and battery drain. If you aren't intimidated by working with automobiles, you can install the IB200 on your own in a matter of minutes.

Power drill

Instructions

- 1
  Turn off your vehicle and open the hood. Locate an area next to the car battery that can accommodate the size of the IB200.
- 2
  Place the mounting bracket for the IB200 over a free area of metal near the battery and mark the holes at either end of the bracket.
- 3
  Use your power drill to drill holes through the metal.
- 4
  Wrap the mounting bracket around the body of the IB200 and align it with the two holes you just drilled. Make sure the connector terminals at the top of the IB200 are facing up.
- 5
  Insert the included mounting bolts into the holes on the bracket and use the included washers to secure the bolts.
- 6
  Connect one of the included lead wires to the positive terminal on the car battery.
- 7
  Connect the other included lead wire to the negative terminal on the car battery.

How to Check for Leakage in a DC Circuit

How to Set a Meter Base

Electrical Repairs