Measure the surface to determine the length of linear LED lighting needed. Clean off any dust or debris from the surface -- this helps the light's adhesive backing stick properly.
Separate any excess tape lighting from the circuit by simply disconnecting at the marked connections -- these power connector sections occur every 12 or 20 inches depending on product. You can also use scissors to cut the tape lighting at marked intervals every 4 inches.
Peel off the preapplied adhesive backing from the lights and stick firmly to the clean surface. You can also use the acrylic clips to mount lights to the wall if desired -- use the mounting screws provided in the packaging to secure the acrylic clips to the wall, then snap the tape lighting into place.