Locate the center of the paperboard by drawing a diagonal line from corner to corner with the ruler and pencil. Draw a line between the opposite corners to make an X. Center is where the lines meet.
Coat the bottom of the socket with glue and press it to the center of the paperboard. Hold the socket in place for at least 30 seconds before letting go. Screw the lightbulb into the socket.
Place a dab of glue at each end of one side of a craft stick. Place the stick glue side down on the edge of one side of the paperboard. Glue a second stick to the opposite side the of the board.
Glue a third stick on the third side of the paper board. The ends of the stick will sit on one end of each of the already glued sticks. Glue the last stick to the opposite side, making sure the stick sits on top of the socket cord. This makes one square with the sticks.
Continue gluing the sticks until the bulb is completely covered.
Glue another square of sticks at the top, but move the sticks closer to the middle. The left edge of one stick will rest just above the right edge of the stick below. Make smaller and smaller squares until they meet in the middle. The ends of the sticks will stick out.