How to Install a Door Latch on a Whirlpool Duet Front Load Washer

GE front load washers require a tight seal at the front of the machine to prevent leaks while the washer is running. A rubber gasket handles the majority of the sealing responsibilities. The door latch catches the door and ensures that it's sitting flush with the front of the machine. The latch also needs to sit flush for the washer to run at all. Repairing a faulty latch is a cheap repair. Obtain GE parts from a reputable dealer.

Screwdriver
Door latch replacement

Instructions

- 1
  Unplug the GE washer from the wall.
- 2
  Remove the three screws from the back of the washer top. Pull the top forward, and lift it off of the washer.
- 3
  Pull out the detergent tray. Press down on the release button, and pull out the tray to remove it.
- 4
  Remove the three screws from the top of the control panel and the one screw from behind the detergent tray. Pull out the control panel, and let it hang.
- 5
  Open the washer door and remove the three screws from the door latch. Pull out the latch to expose the wire.
- 6
  Pull the connector for the wires attached to the door latch at the control panel. Pull the latch out of the machine.
- 7
  Slide the wires for the new latch through the front panel of the machine. Connect the door latch wires to the control panel. Reassemble the washer.

How to Replace the Seal on a Kenmore Front

How to Drain Water From a Broken Washing Machine With a Burning Rubber Smell

Washer & Dryers