Home Garden

How to Replace the Tub Gasket on a Frigidaire FWT647GHS0

The Frigidaire FWT647GHS0 is a front-load washing machine. That means the access door is located on the front of the unit, rather than the top. When you close the door to the unit, it seals and holds the water inside. This is due to the gasket. The gasket is a rubber seal on the inside of the door. If you have a damaged gasket, you should replace it immediately; if you don't, it could lead to leakage.

Things You'll Need

  • Phillips screwdriver
  • Pliers
  • Liquid soap
Show More

Instructions

    • 1

      Turn off your Frigidaire washer and unplug the power cable.

    • 2

      Remove the screws on the rear of the top panel of the washer. Remove the panel and set it aside.

    • 3

      Pull the detergent tray out of the front of the unit. Press down on the tab at the back of the tray and remove the tray completely.

    • 4

      Remove the screws on the tray housing.

    • 5

      Remove the screws on the top of the unit's control panel.

    • 6

      Press the tabs on the top of the control panel and remove the control panel from the front of the unit.

    • 7

      Open the door of the washer and remove the metal wire clamp wrapped around the circular washer opening.

    • 8

      Remove the screws from the bottom of the front panel of the washer and remove the screws at the top of the panel. Remove the panel.

    • 9

      Unplug the wiring harness plugged into the rear of the panel and set the panel aside.

    • 10

      Pull the tub gasket out of the opening.

    • 11

      Line the creases of the new tub gasket with liquid soap to lubricate it.

    • 12

      Fit the new tub gasket in the opening and reverse the steps for reassembly.