How to Replace Suspension Springs on a Kenmore Elite Front Load

Kenmore front-load washers have a tub that is set on its side. The tub agitates back and forth during the washing cycle. To prevent the tub from shaking too much during the washing cycles, a series of suspension springs are attached to the drum. If the tub is shaking and the washer is properly balanced, the springs on your Kenmore machine may be worn out. Replacing the springs requires taking apart the washer tub.

Screwdriver
Pliers
Suspension springs

Instructions

- 1
  Unplug the washer from the wall and pull it out so you have access to the back of the machine.
- 2
  Remove the three screws from the top cover at the back of the machine. Pull on the cover and lift up to remove it.
- 3
  Remove the screws from the top of the control panel. Pull out the soap dispenser drawer and remove the screw from behind it.
- 4
  Open the door of the unit and remove the screws from the door latch.
- 5
  Slide a flathead screwdriver between the wire on the front of the machine and the door gasket.
- 6
  Remove the four screws from the front of the machine in the door well and remove the front panel.
- 7
  Lift up on the washer tub with the help of a partner. Grab the springs with a pair of pliers and pull them off the tub.
- 8
  Hook the new springs onto the tub.
- 9
  Reassemble the unit.

My Laundry Hookup Has a Leaking Faucet

How to Fix the Belt on a GE Washer

Washer & Dryers