How to Remove a Frigidaire Bracket Stack

Unplug the Frigidaire washer and dryer power cords from the electrical outlet. Shut off the two water supply spigots supplying water to the washer.

Loosen the clamp screw securing the duct hose to the dryer exhaust with a Phillips screwdriver and pull the dryer duct hose away from the dryer.

Remove the caps covering the screws securing the front brackets to the front of the dryer. The caps might require some prying with a utility knife. Remove the screws securing the front bracket to the front of the dryer with a nut driver.

Grab the bottom of one side of the dryer while your helper grabs the bottom of the other side. Lift the front of the dryer and pull it forward to unhook the rear of the dryer from the rear brackets. Lift the dryer off the washer with the assistance of your helper.

Remove the screws securing each of the stacking brackets to the inside of the washer with the nut driver. The screw heads are pointing to the center of the washer.

Position the front of the washer top panel into the channels on the inside top of the washer sides. Push the top panel forward until it engages under the top of the control console. Secure the back flange of the top panel to the rear panel with the retaining screws and a nut driver.