Removing the Side Panels from the LG Tromm

The LG Tromm is a dryer that has several functions, including different drying programs and an electronic control panel. Some problems that occur with the dryer can be resolved by pressing “Start/Pause” twice then selecting a new cycle, followed by “Start” again. However, some issues with the dryer may be with some of the internal components, and the LG dryer must be disassembled, including the top and side panels, to access these components.

Phillips head screwdriver

Instructions

- 1
  Disconnect the power to your LG Tromm dryer and turn the gas valve, if applicable, clockwise until it's firmly closed.
- 2
  Locate and remove the three screws on the upper plate near the top of the dryer with a Phillips head screwdriver.
- 3
  Place a hand on each side of the top plate and push the plate backward until the plate is clear of the tabs on each side. Lift up on the plate to remove it.
- 4
  Locate the screws on each side of the control panel frame and remove them.
- 5
  Open the cover on the control panel and disconnect the wires at the connectors. Pull forward on the control panel assembly and then up and out to remove it.
- 6
  Remove the screws on the control panel display and take apart the control panel assembly.
- 7
  Take out the screws from around the sides of the dryer door and set them aside. Lift off the dryer door.
- 8
  Remove the four screws on the top of the cabinet cover and disconnect the door switch harness at its connector point.
- 9
  Pull the sides of the dryer from the front of the washtub.

Washing Machine Drain Line Capacity

How to Replace a Baffle for an Electrolux Washer

Washer & Dryers