# How to Replace a Washer Suspension Rod
The main component of your washing machine, the tub, is held up by suspension rods that keep it from falling to the bottom of the unit. When your tub leans to one side or isn’t level, it’s a sign something is wrong with your rods. Replacing the rods can vary depending on the model and style of the washer, but generally, you just thread each new rod through the opening on the top and attach it to the tub.
Things You'll Need
- Screwdriver
- Replacement suspension rods
Instructions
-
-
1
Turn off your washer and unplug it from the power source. Remove the front panel of the washer. Remove the main top of the washer.
-
2
Unclip the suspension rod from its holder on the drum at the bottom of the rod. Pull the rod up through the whole in the top of the unit with one hand and pull the top plastic support out of the way. Lift the entire rod up through the opening.
-
3
Lower the new rod into the hole and attach the bottom to the tub’s clip. Hold the rod up with one hand and slide the top plastic support in place. Slide the rod in the hole the rest of the way and rest it on the top plastic support.
-
4
Replace the front panel and main top back onto the washer. Plug the unit back in and use as desired.
-
1
Washer & Dryers
- How to Replace an LG Washer Bearing
- How to Replace the Suspension Springs on a Whirlpool Duet Washer
- How to Replace the Clutch on a Whirlpool Top Loader Washer
- How to Replace Rubber Bands in a GE Washer
- How to Replace a Washer Belt on a Maytag Front-Load
- How to Replace a GE Washer's Green Rod
- How to Replace a Suspension Spring on a Top-Load Frigidaire Washer
- How to Fix a Back Suspension Rod on a GE WHDSR315DAWW Washer
- How to Replace a Suspension Spring & Rod Assembly in a Kenmore Washer
- How to Replace a GE Washer Spin Bearing
- How to Replace a Baffle for an Electrolux Washer
- How to Replace the Belt in the GE Top Loader Washer
