Move your Kenmore washer and dryer combo away from the wall and disconnect the power cord from the wall outlet.
Remove the screws from the top and bottom of the rear panel using a Phillips screwdriver. Lift up and remove the rear panel from the washer.
Locate the air shocks part at the bottom center of the washer unit and then push in the locking tab on the side of the shocks.
Pull out the pin out from the shocks using needle-nose pliers and then remove the screws holding the shocks part to the washer.
Lift up and remove the entire part from the washer. Place the new shocks part into the same position and reinsert the screws to the part.
Push the pin back through the middle of the shocks part and place the rear panel back onto the washer.
Reinsert the screws into the rear panel and reconnect the power cord to the wall outlet.