Unplug your Whirlpool ED25QF refrigerator’s power cord from the power outlet.
Line a flat-head screwdriver up to one of the two slots on the bottom of the exterior ice dispenser’s trim panel.
Turn the screwdriver slowly until the bottom of the trim panel pops away from the refrigerator and then repeat for the other slot.
Push the trim panel upward, from the bottom, until it slides away from the ice dispenser.
Unscrew the two screws along the side of the chute by using a Phillips screwdriver. If it is the water dispenser, there may be a screw located in the center of the chute along with the spigot. You can unscrew the screw and remove the water spigot.
Pull the chute away from the dispenser.
Line the new chute up and screw it into place. For the water spigot, line the spigot back up to the insertion hole and then screw it back into place.
Line the trim panel back up at the top of the dispenser and then slide it back into place.
Push the bottom of the trim panel into place until it clicks into the secured position.
Plug the power cord back into the power outlet.