How to Adjust the Door Closer on a GE Profile

When you are using your General Electric Profile model refrigerator, it is important that the door of the refrigerator closes properly. If your door does not shut all the way, cold air can escape and your food may not stay fresh. To fix the problem, make sure your door is level by adjusting the door hinge's adjusting screws, which are located near the bottom hinge of the door.

1/4 inch wrench

Instructions

- 1
  Open the door on your GE Profile refrigerator, and then open and close the door to determine whether the door needs to be lowered or raised. If the door hangs low when opened then you should raise it, and if the door stands up too high then you should lower it.
- 2
  Locate the adjusting screw at the bottom hinge on the side of the door.
- 3
  Turn the adjusting screw to the right using a 1/4 inch wrench if you want to raise the door.
- 4
  Turn the adjusting screw to the left if you want to lower the door.
- 5
  Close the door and then open it again to the test the alignment of the door.
- 6
  Adjust the screw until the door is leveled to meet your needs.

Troubleshooting a KitchenAid Refrigerator Ice Maker with a Red Flashing Light

How to Adjust the Paddle on a GE Ice Maker

Refrigerators