Home Garden
# Home & Garden >> Home Appliances >> Other Home Appliances

How to Replace an Electrode in the Frigidaire Oven

Frigidaire gas ovens are available as built-in models or as part of free-standing ranges. The ovens have two burners, one on top used for broiling food and one on the bottom of the oven used for all other cooking. Both burners have an electrode that uses sparks to light the gas emitted by the burner. If either electrode fails, the burner on which it is installed will not light. To repair the oven, replace the electrode.

Things You'll Need

  • Flat-head screwdriver
  • Phillips screwdriver
Show More

Instructions

    • 1

      Turn off the range's power supply in your home's service panel.

    • 2

      Open the oven door, and flip the hinge locks down. The hinge locks are located on each door hinge, and when locked, they are flush against the doorjamb. If necessary, use a flat-head screwdriver to pry the hinge locks down, unlocking the door.

    • 3

      Close the door to the "broil stop" position, and lift the door up and off the range. Set the door aside.

    • 4

      Remove the oven racks from inside of the oven.

    • 5

      Remove the lower panel of the range if you're replacing the bake igniter. The panel is secured using two thumb screws on the rear of the panel, and it lifts right out. If you're replacing the broil burner, skip this step.

    • 6

      Remove the burner shield assembly by removing the screws securing it in position. On some Frigidaire models, the broil burner is attached to the burner shield and is removed with the assembly.

    • 7

      Remove the screws securing the igniter to the side of the burner or to the oven frame. Pull the igniter away from the rear wall, and disconnect the wire connector. Remove and discard the igniter.

    • 8

      Connect the wire connector of the new igniter to the range's wire harness, and tuck the wire behind the rear wall of the range. Secure the new igniter to the side of the burner or to the oven frame using the screws that were removed.

    • 9

      Reinstall the burner shield assembly, using the screws that were removed to secure it into position.

    • 10

      Replace the lower panel of the oven, if applicable to your repair.

    • 11

      Reinstall the oven racks.

    • 12

      Reinstall the oven door, and flip up the hinge locks to lock the door to the doorjamb.

Previous:

Next:

Other Home Appliances
  1. How To Replace the Igniter on a Maytag Oven
  2. How to Replace the Burner Ignitor on a Frigidaire Gas Range
  3. How to Replace the Spark Igniter in a Gas Frigidaire
  4. How to Replace the Thermal Switch on a Frigidaire Double Oven
  5. How to Replace the Electrodes in a Frigidaire Cooktop
  6. How to Replace the Oven Ignitor in a Maytag Range
  7. How to Replace the Top Burner on a Frigidaire Range FEFL79HSA
  8. How to Replace a Frigidaire Oven Element
  9. How to Replace the Thermostat in a KitchenAid Convection Oven
  10. How to Replace the Glass on a Frigidaire GLEFZ379FC Oven
  11. How to Replace the Inner Glass of an Oven Door on a Frigidaire Crown
  12. How to Replace a Frigidaire Oven Hinge

Home Garden © https://www.98905.com