# How to Remove the Inside Screen for a Maytag Microwave
When installing a Maytag microwave for the first time in your kitchen, you must install the top and bottom brackets above and below the microwave door. The inside screen, also installed the trim kit frame, attaches to the brackets and fits into the inside of a microwave to work as a screen to the door. If the screen appears to be ripped or broken, you can remove it at anytime and replace it with a new part, which you can order from the manufacturer or from an online retailer.
Things You'll Need
- Screwdriver
Instructions
-
-
1
Unplug the power cord connected to the Maytag microwave from the wall outlet.
-
2
Open the microwave door by pressing down on the front door button, and make sure the door is open all the way.
-
3
Locate two 1/2-inch screws on the bottom of the inside screen and two 1/2-inch screws on the top of the screen.
-
4
Remove all four 1/2-inch screws from the inside screen using a screwdriver, and the screen will become disengaged.
-
5
Lift up screen and pull it out of the microwave so that it goes over the microwave door.
-
6
Inspect the inside screen for any damage, such as rips in the trimming, and replace the part if necessary.
-
1
Microwave Ovens
- How to Fix the Transformer Fuse on a Maytag Microwave
- How to Change the Humidity Sensor for a GE Microwave
- How to Remove the Casing on an Emerson Microwave MW8992SB
- How to Remove the Charcoal Filter in a GH9115XE Microwave
- How to Change the Light Bulb Inside a Maytag Microwave Hood
- How to Change the Power Settings for a Maytag Microwave
- How to Remove a Microwave From the Wall
- How to Remove the Upper Vent on a Built-in Microwave
- How to Remove the Screen on a GE JVM1650CH Microwave
- How to Remove the Door Grid on a Microwave Oven
- How to Remove a GE Microwave
- Specifications for the Maytag UMC5200BAS
