# How to Replace a Thermostat on a Sears Kenmore Dishwasher
Things You'll Need
- Phillips screwdriver
- Needle nose pliers
Instructions
-
-
1
Disconnect the electrical power from your Sears Kenmore dishwasher by turning it off from your kitchen circuit breaker.
-
2
Remove the four screws from the lower panel of the dishwasher using a Phillips screwdriver.
-
3
Lift up and remove the lower panel, then locate the thermostat under the dishwasher with an orange and white wire connected to it.
-
4
Disconnect the wires from the thermostat using needle nose pliers. Remove the screw from the bracket holding the thermostat in place.
-
5
Pull the thermostat out of the dishwasher. Insert the new thermostat into the same position within the dishwasher.
-
6
Reinsert the screw into the bracket to hold the thermostat in place, then reconnect the wires to the thermostat.
-
7
Place the lower panel back onto the dishwasher and reinsert the screws. Turn the electrical power back on from the kitchen circuit breaker.
-
1
- How to Replace the Electrical Plug on a Kenmore Dishwasher
- How to Replace an Active Vent in a Kenmore Dishwasher
- How to Replace a Kenmore Fridge Thermostat
- How to Replace the Float Turn on a Kenmore Dishwasher
- How to Clean the Pump on a Sears Kenmore Dishwasher
- How to Replace a Kenmore Dishwasher Drain Pump
- How to Replace the Heating Coil on a Kenmore Dishwasher
- How to Replace a Rubber Valve on a Kenmore Dishwasher Feed Tube
- How to Replace the Gasket in a Kenmore Elite Dishwasher
- How to Replace a Door Hinge on a Sears Dishwasher
- How to Replace the Panel on a Kenmore Elite Dishwasher
- How to Replace the Access Panel on a Kenmore Dishwasher
