# How to Connect a Flexible Water Supply Line to the Elbow Piece of a Whirlpool Dishwasher
Older models of Whirlpool dishwashers have a water inlet valve, which regulates the flow of water into the dishwasher. This type of water inlet valve requires a brass elbow to be installed on the bottom of the valve, to which the water supply line connects, unlike newer inlet valves that rely on a rubber washer to form the seal. Once the water supply line is connected, the dishwasher is almost ready for use.
Things You'll Need
- Screwdriver
- Adjustable wrench
Instructions
-
-
1
Remove the screws that secure the bottom panel of the dishwasher to the appliance with a screwdriver. Remove the bottom panel.
-
2
Locate the water inlet valve. On Whirlpool models, the water inlet valve is located on the left side of the lower compartment of the dishwasher.
-
3
Thread the water supply line connector onto the brass elbow then hand-tighten the connector. Use an adjustable wrench to further tighten the water supply line.
-
4
Turn on the water supply valve and inspect the connection for leaks.
-
5
Replace the lower access panel and secure it into position with the screws that were removed.
-
1
Dishwashers
- How to Remove the Line or Hose From a Whirlpool Dual Water Valve
- How to Tighten a Dishwasher's Elbow
- How to Install the Float Assembly in a Whirlpool Dishwasher
- How to Check the Valve on Your Kenmore Elite Dishwasher
- How to Hook Up a Water Line to a Dishwasher
- How to Clean a Fill Valve in a Whirlpool Dishwasher
- How to Troubleshoot the GHDA960K03WW
- How to Clean a Corroded Dishwasher Water Valve
- How to Remove the Drain Line in a Whirlpool Dishwasher
- How to Disconnect the Water Line and Drain on a Dishwasher
- How to Troubleshoot a Whirlpool Dishwasher DU1145XTPB7
- How to Run a Hot Water Line for a Dishwasher
