How to Disassemble a Triton XL Dishwasher Door

GE manufactures many home appliances, including dishwashers. The Triton XL is a built-in dishwasher model. If the door on your Triton XL isn't opening and closing properly, it could be the result of a bad hinge or spring. In order to properly diagnose the problem, you can remove the door from the front of the dishwasher. This will give you access to the hinges and springs.

Phillips head screwdriver

Instructions

- 1
  Turn off your Triton XL dishwasher and slide it out of its enclosure so you can access the side and top panels of the unit.
- 2
  Remove the screws on the rear of the top panel with a Phillips head screwdriver then remove the panel and set it aside.
- 3
  Take out the screws on the rear and bottom of the side panels then remove the side panels and set them aside. Open the dishwasher door. You now have access to the spring and hinges. The spring connects to the rear of the hinges and the dishwasher frame.
- 4
  Lift one of the springs up to unhook it from the latch at the top of the dishwasher frame. Unhook it from the back of the hinge as well. Repeat with the spring on the other side of the dishwasher.
- 5
  Pop the circular washer off of the top of one of the metal hinges with the tip of your screwdriver. Repeat with the washer on the other hinge.
- 6
  Unhook one of the hinges from the latch at the back of the dishwasher door. Repeat with the other hinge.
- 7
  Remove the door from the dishwasher.

How to Install Bosch Dishwasher Water Valves

How to Replace the Door Gasket on a Frigidaire Dishwasher

Dishwashers