How To Disconnect the Timer From a Maytag Washer

When starting a load of clothes in a Maytag washer, one of the most important components is the timer located on the top control panel of the unit. If the load continues after the timer buzzes or if the cycle finishes before the timer stops, a faulty timer may be the culprit. The timer can be removed from the control panel at any time to inspect it. If the timer needs to be replaced, a new part can be ordered from the manufacturer or an online or brick-and-mortar retailer.

Flathead screwdriver
Phillips screwdriver
Needle nose pliers

Instructions

- 1
  Move the Maytag washer away from the wall. Disconnect the power cord from the wall outlet.
- 2
  Insert a flathead screwdriver into the timer dial. Press down on the spring clip to release the dial from the control panel.
- 3
  Remove the two screws from the back top of the control panel using a Phillips screwdriver.
- 4
  Remove the two mounting screws from the timer on the front of the control panel.
- 5
  Lift the control panel so that it hangs on its back hinges. Disconnect each wire from the timer using needle-nose pliers.
- 6
  Remove the entire timer part from the control panel. Inspect the part for damage, then replace the part if necessary.

How to Fix a Drain Pump on a GE Profile Dishwasher

How to Repair a Dishwasher Hinge

Dishwashers