Unplug the power cord or turn off the circuit breaker that powers the washing machine.
Open the washer door. Insert the tip of the flat-blade screwdriver under the bottom of the tub seal. Pry the wire spring clamp off the tub seal to remove it.
Push the outside edge of the tub seal into the tub opening.
Wedge the wood block between the front panel and the tub 10 inches from the bottom of the cabinet.
Pull the top of the tub seal downward and toward you slowly until the spring coil holding the tub seal is visible. Pull the spring coil off.
Pull the tub seal off the front of the washer tub.
Position the new tub seal over the tub. Replace the spring coil.
Remove the wood block from the washer cabinet. Wrap the front of the tub seal over the door lip. Replace the wire spring clamp over the edge of the tub seal.
Remove the two screws along the bottom of the lower front panel. Lift the panel off the washer cabinet.