How to Disassemble an LG Steam Dryer Model DLE8377NM

The LG DLE8377NM is a front-loading automatic dryer designed for home use. Most of the primary components and mechanisms cannot be accessed with the dryer fully assembled. The control panel on top of the unit as well as the outer dryer cabinet can be taken apart in order to gain access to internal components. With the dryer taken apart, components such as the motor, pulleys, heating element and blower can be inspected, repaired or replaced.

Phillips screwdriver
Putty knife

Instructions

- 1
  Disconnect the dryer power cord.
- 2
  Remove the three screws on the top of the control panel. Pull the control panel toward the front of the dryer cabinet.
- 3
  Remove the screws holding the inside portion of the control panel to the cabinet. Lift the control panel off of the dryer.
- 4
  Insert the putty knife blade into the gap between the front and top panels. Press the knife into the internal clips about three inches from each corner. Lift the top panel up and back.
- 5
  Open the dryer door. Remove the two screws on the inside of the door frame.
- 6
  Remove the two screws on the top of the front panel. Lift the front panel away from the dryer. Unplug the door switch connector. Set the front panel aside.
- 7
  Remove the four screws holding the shroud in place in front of the drum. Lift the drum shroud off of the dryer.
- 8
  Move the idler pulley under the drum toward the left to loosen the belt. Slide the belt off of the pulleys.
- 9
  Lift the drum out through the front of the dryer cabinet.

Taking Out the Door Boot on a Kenmore

How to Disassemble a Whirlpool Washing Machine Model TAWS800JQ2

Appliance Repair