Unplug the power cord. Open the door.
Grasp the wire clamp from the bottom of the rubber seal with the pliers. Pull the wire clamp off.
Peel the front of the seal off the door lip. Fold the seal inside the tub.
Disconnect the wire connector from the bottom of the door latch assembly. Close the door.
Open the pump filter housing cover. Disconnect the drainage tube. Remove the screw holding the pump filter in place. Pull out the pump filter.
Remove the screws along the back of the top panel. Lift off the top panel.
Slide the detergent dispenser drawer out. Press the locking tab down at the back of the drawer. Remove the drawer from the cabinet.
Remove the screws holding the control panel to the cabinet. Lift the control panel and set it on top of the washer.
Remove the screws holding the front panel in place. Lift off the front panel.
Grasp the rubber seal clamp with needle-nose pliers. Lift off the clamp.
Pull the boot seal off the front of the tub.
Position the new boot seal on the tub. Align the notch on the seal with the arrow on the top of the tub.
Reverse the disassembly steps to put the LG Tromm washer back together.