Disconnect the power cord from the wall outlet. Turn off the water faucets connected to the water inlet hoses.
Unscrew the water inlet hoses from the back of the GE washer. Set the ends of the hoses in a bucket to collect the water that drips out.
Remove the screws that hold the rear access panel in place. Lift the panel off of the back of the washer.
Rotate the large pulley while sliding the old drive belt off. Remove the belt after it comes all the way off the pulleys.
Position the belt around the small pulley. Rotate the large pulley by hand while working the belt onto it.
Replace the rear panel. Install the screws that hold it in place. Screw the water hoses onto their sockets.