Disconnect the power cord from the electrical socket.
Remove the screws that connect the control console to the Hotpoint dryer cabinet. Remove the plastic trim from the top of the console.
Remove the screws from the top of the control console. Unplug the wire connector leading from the console to the cabinet. Set the control console off to the side.
Remove the two screws on the front panel. Remove the front panel from the dryer cabinet.
Push the idler arm toward the back of the dryer to loosen the belt. Remove the belt from the pulleys and tumbler drum.
Remove the drum from the dryer cabinet.
Remove the screws securing the heating element assembly to the inside of the Hotpoint dryer cabinet. Set the heating element aside.
Remove the screws holding the rear bearing assembly to the cabinet.
Position the new bearing assembly inside the Hotpoint dryer. Reverse the previous steps to reassemble the unit.