How to Change a Belt for a Performa Dryer Model PDET910AYW

The Maytag Performa PDET910AYW is a front-loading automatic dryer designed for home use. The dryer is equipped with a motor and pulley system that powers the movement of the belt. As the belt rotates, it turns the tumbler drum. One possible sign of a broken belt is if the drum is not rotating properly or at all. Change the faulty belt with a new one to keep your Performa dryer working correctly.

Phillips screwdriver
Putty knife

Instructions

- 1
  Unplug the PDET910AYW from the electrical outlet.
- 2
  Insert the putty knife blade between the top panel and front panel. Lift the knife up on the right and left corners to unhook the top panel from the cabinet of the Performa dryer.
- 3
  Lift the top panel up to rest on its hinges.
- 4
  Remove the screws near the top of the front panel on the right and left sides. Lift the front panel up to detach it from the cabinet.
- 5
  Disconnect the wire connector leading to the door switch. Set the front panel aside.
- 6
  Move the idler pulley arm toward the front of the Performa PDET910AYW dryer to relieve belt tension.
- 7
  Remove the belt from the pulleys and drum.
- 8
  Wrap the new belt around the drum. Feed the other end around the pulleys. Move the idler pulley arm toward the back of the Performa PDET910AYW dryer to tighten the belt.
- 9
  Replace the front panel. Connect the door switch connector into its socket. Install the 2 screws that hold the panel in place.
- 10
  Lower the top panel. Press down on the panel to engage the two internal clips.

Removing the Front of a Frigidaire GLEQ942CSO

How to Check a Broiler Element in a Kenmore Oven

Appliance Repair