# The Removal of the Idler Pulley on a Maytag MDE2600AYW
The Maytag MDE2600AYW is a front-loading automatic dryer designed for home use. The belt connected to the drum relies on the idler pulley to maintain proper tension. For some repair procedures, removing the idler pulley in order to access other components is necessary. If the idler pulley is damaged or broken, you must remove it and place it with a new part. To do this, you need to open the dryer cabinet to gain access to the idler pulley.
Things You'll Need
- Phillips screwdriver
Instructions
-
-
1
Unplug the power cord. Open the door.
-
2
Remove the four screws around the inside edge of the door.
-
3
Pull the front panel away from the MDE2600AYW dryer cabinet to disconnect it. Lift the panel up and set aside.
-
4
Disconnect the wire connector leading to the door switch.
-
5
Remove the four screws holding the shroud to the Maytag dryer cabinet. Lift the shroud out through the front.
-
6
Pull the belt off of the pulleys. Remove the belt from the drum. Lift the drum out of the dryer cabinet.
-
7
Unhook the spring at the base of the idler pulley arm. Remove the screw holding the idler pulley assembly to the motor support bracket.
-
8
Pull the idler pulley assembly out of the dryer.
-
1
Appliance Repair
- How to Adjust the Drive Idler Pulley on a Hydrostatic Simplicity 7113
- The Anti-Siphon Valve Leaks on My Maytag Washer
- How to Replace the Clutch in a Maytag FAV9800 Tl Washer
- How to Light the Pilot on a Maytag Range
- How To Replace the Igniter on a Maytag Oven
- How to Change the Handle on a Maytag Microwave
- How to Install an Idler Pulley in a Maytag Washing Machine
- Removing the Freezer Panel on a Maytag PBF1951HEQ
- The Front Panel Removal of the GE WWSE5240G3WW Washer
- How to Disconnect the Motor & Idler Pulley on a GE Dryer Drum
- The Removal of the Broiler Drawer on a Tappan Range
- The Removal of Schefflera
