Home Garden

How to Replace the Heating Element in a Frigidaire GLEH1642DS1 Gallery Dryer

The Frigidaire GLEH1642DS1 Gallery is a front-load washer and dryer combo, or laundry center. The dryer portion is equipped with a heating element that provides the high temperature needed to dry wet laundry. Should the heating element stop working correctly, the dryer will not produce heat. The tumbler drum will rotate, but without properly drying the clothing. Replace the faulty heating element with a new one to keep the dryer on your unit working properly.

Things You'll Need

  • Phillips screwdriver
Show More

Instructions

    • 1

      Remove the two screws at the top of the rear dryer access panel. Lift the panel up to remove it.

    • 2

      Move the idler pulley to the left. Remove the belt from the motor pulley.

    • 3

      Remove the ten screws holding the top panel in place. Lift the top panel off of the dryer.

    • 4

      Remove the four screws connecting the control console to the dryer cabinet.

    • 5

      Pull the console down and away from the Frigidaire GLEH1642DS1 to disconnect it. Unplug the wire connector leading to the console.

    • 6

      Remove the two screws holding the front panel to the side panels.

    • 7

      Remove the four screws holding the front panel to the top of the cabinet. Pull the front panel forward to remove it.

    • 8

      Lift the drum up to disengage it from the rear bearing. Slide the drum out through the front opening.

    • 9

      Unplug the two wires connected to the heating element assembly in the inside rear cabinet wall.

    • 10

      Remove the four screws holding the element assembly to the cabinet. Remove the old heating element from the dryer.

    • 11

      Install the new heating element into the dryer cabinet. Install the four screws that hold it in place. Plug the wire connectors back into their sockets. Repeat the previous steps in the opposite sequence to reassemble the Frigidaire GLEH1642DS1.