Unplug the washing machine power cord before servicing the unit.
Remove the screws along the back of the washer cabinet connected to the top panel. Lift the top panel off the washer cabinet.
Slide the soap dispenser out as far as it will go. Press down on the release tab near the back of the dispenser. Pull the dispenser out and set it aside.
Remove the screw to the left of the soap dispenser compartment.
Pull the control panel away from the washer to unhook it. Set the panel on top of the WFW9200SQ00 washer cabinet.
Open the door. Remove the three screws next to the door switch.
Remove the three screws along the bottom of the toe panel. Lift the toe panel up and away from the washer to remove it.
Remove the screws holding the four corners of the upper-front panel to the cabinet. Lift the front panel off the washer.
Peel the edge of the seal bellow down to locate the bellow clamp. Loosen the screw on the clamp. Pull the clamp off.
Pull the old bellow out of the washer cabinet. Insert the new seal bellow in its place.
Reverse the disassembly steps to put the Whirlpool WFW9200SQ00 washer back together.