# How to Access the Ignitor on a GGW9878LW0 Dryer
The ignitor in the Whirlpool GGW9878LW0 automatic gas dryer lights the burner system when the dryer is turned on. If the ignitor isn't functioning, it may need to be repaired or replaced. The ignitor can be accessed by removing part of the outer cabinet.
Things You'll Need
- Flat-blade screwdriver
- Phillips screwdriver
Instructions
-
-
1
Unplug the dryer power cord. Turn off the gas supply leading to the dryer.
-
2
Insert the tip of the flat-blade screwdriver into the gap above the toe panel below the upper front panel. Press the screwdriver into the internal clips four inches from each side.
-
3
Pull the toe panel off and set it aside.
-
4
Unplug the wiring harness connectors leading to the burner assembly by hand.
-
5
Remove the screws holding the ignitor to the lower portion of the burner assembly. Lift the ignitor out of the dryer cabinet.
-
1
Appliance Repair
- How to Test the Thermodisc in a Dryer
- How to Test the Ignitor on a Maytag Dryer
- How to Access the Igniter on a Whirlpool Dryer LGR5620KQ1?
- How to Put an Ignitor in a Dryer
- How to Replace the Thermistor in a Dryer
- How Do You Get to the Ignitor in a Roper Gas Dryer?
- How to Access the Motor Assembly on a Frigidaire Dryer FSE747GES0
- How to Access the Belt in an Amana Dryer
- How to Repair the Igniter on a Maytag Dryer
- How to Determine if the Ignitor Is Bad on My Dryer?
- How to Test the Ignitor in a LGR7646EQ2 Gas Dryer
- How to Access the Door Switch on an Inglis Dryer
