Disconnect the dryer power supply. Remove the lint screen from its compartment. Remove the screws next to the lint screen compartment.
Insert the tip of the putty knife into the gap between the front and top panels. Pry the knife up on the right and left corners to detach the top panel.
Lift the top panel up. Rest the panel against the wall behind the Whirlpool Special Edition dryer.
Remove the two screws at the top of the front panel. Tilt the top of the front panel away from the dryer. Lift the panel up to disconnect it. Set the panel aside.
Slide the belt off of the pulleys below the dryer drum. Slide the belt off the drum.
Position the new belt along the belt groove of the drum. Loop the other end around the pulleys.
Replace the front panel. Install the two screws holding it to the cabinet.
Lower the top panel onto the dryer cabinet. Install the two screws next to the lint screen compartment.